To cancel the setting, proceed as follows:
– briefly press button MODE: ON flashes on the display;
– press button
▼: OFF flashes on the display;
– press the MODE button briefly to return to the menu
screen or press the button for longer to return to the stan-
dard screen without memorizing.
Headlight sensor sensitivity adjustment
(for versions/markets where provided)
With this function it is possible to adjust the rain headlight
sensitivity according to 3 levels.
To set the required sensitivity level proceed as follows:
– briefly press button MODE: the previously set sensitiv-
ity “level” starts flashing on the display;
– press button
▲ or ▼ to adjust;
– press the MODE button briefly to return to the menu
screen or press the button for longer to return to the stan-
dard screen without memorizing.
Speed limit (Speed Beep)
This function enables setting of the vehicle speed limit
(km/h or mph). When this limit is exceeded the driver is
immediately alerted (see section “Warning lights and mes-
sages”).
To set the desired speed limit, proceed as follows:
– briefly press button MODE: the display will show the
wording “Speed Beep”;
– press button
▲ or ▼ to select speed limit activation (On)
or deactivation (Off);
– if the function has been activated (On), press buttons
▲ or ▼ to select the required speed limit and then press
MODE to confirm;
NOTE. The speed may be set in the range from 30 to 200
km/h, or from 20 to 125 mph according to the previously cho-
sen unit (see “Setting the distance unit” paragraph ) described
below. The setting will increase/decrease by five units each
time button
▲
/
▼
is pressed. Hold down button
▲
/
▼
to in-
crease/decrease the setting rapidly. Complete the setting by
briefly pressing the button when you approach the required
setting.
– press the MODE button briefly to return to the menu
screen or press the button for longer to return to the stan-
dard screen without memorizing.
28
DASHBOARD
AND CONTROLS
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
001-036 DUCATO LUM EN 11-02-2010 13:53 Pagina 28