Fiat Ducato - Reading the Current Time; Programming the Activation Time

F0N0153m
fig. 57
Continuing to press the buttons 5 or 7 will move the dig-
its on the clock forwards or backwards faster.
Reading the current time fig. 57
To read the current time, press the button 4: the time will
appear on the display for about 10 seconds and warning
light 9 will come on at the same time.
Programming the activation time fig. 58
Activation can be programmed with an advance of between
1 minute and 24 hours. Three different activation times
may be selected, but only one one can be activated for
each pre-heating cycle.
To program the activation time:
❒ press the button 6: the symbol 10 or the time set pre-
viously and the number 3 corresponding to the prese-
lection recalled will light up in the display for 10 seconds.
68
DASHBOARD
AND CONTROLS
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
F0N0154m
fig. 58
IMPORTANT If you wish to recall other preselected times,
press button 6 from time to time within 10 seconds.
– within 10 seconds, press the buttons 5 or 7 to select the
desired switching on time.
IMPORTANT Confirmation that the time has been stored
is given by:
❒ the disappearance of the activation time;
❒ the presence of preselection number 3;
❒ the lighting of the display.
IMPORTANT When the boiler turns on:
❒ the flame warning light 1 lights up in the display;
❒ the preselection number 3 goes out.
037-122 DUCATO LUM EN 11-02-2010 14:26 Pagina 68