F0N0215m
fig. 105
Notes on use
To clean the TV camera, it is advisable to use a non-abra-
sive cloth when the protective glass is dirty or iced over
(on the outside). It is absolutely necessary to avoid using
any tool for cleaning as this could scratch the glass.
It is also advisable to use a dry non-abrasive cloth when
cleaning the display. The dust that settles on the display
may be removed with special brushes. Avoid using any de-
tergent for cleaning.
The display glass could break in the event of impact. In this
case, do not touch the liquid crystal that emerges from the
display. If this occurs, quickly wash the contaminated parts
with soap and water.
ACTIVATION
The system is activated with the ignition on and reverse
engaged or by means of a dedicated button. If the vehicle
is in motion, e.g. during a reversing manoeuvre, the sys-
tem will operate up to a speed of 15 km/h and go off when
a speed of approximately 18 km/h is exceeded. When re-
verse is deactivated, the image will appear on the display
for a further 5 seconds.
GENERAL WARNINGS
Area of visibility
The area of visibility may vary according to the vehicle po-
sition (full load condition included), according to the vehi-
cle specification and according to weather conditions (high
brightness, rain, snow and fog). Visibility may be reduced
during poor lighting or full load conditions.
The area covered by the TV camera is approximately 3 m
in length and approximately a maximum of 5.5 m in width
fig. 105.
94
DASHBOARD
AND CONTROLS
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
037-122 DUCATO LUM EN 11-02-2010 14:26 Pagina 94
To Next Page
Loading...
