F0N0182m
fig. 169
F0N0827m
fig. 168
For a more accurate reading, it is advisable to check the
pressure reading on the pressure gauge F fig. 168 with
the compressor off and without moving the centre se-
lector from the repair position;
❒
if a pressure of at least 3 bar is not reached within
10 minutes, detach the transparent filler pipe from the
valve and switch off the 12V current pin, then move
the vehicle about 10 metres forward to distribute the
sealant liquid inside the tyre and repeat the inflation
operation;
❒
if after this operation it is still not possible to reach at
least 3 bar after 10 minutes, do not start driving since
the tyre is excessively damaged and the fast tyre re-
pair kit cannot guarantee suitable sealing. Contact the
Fiat Dealership;
❒
if the tyre reaches the pressure specified in “Inflation
pressure” paragraph in the “Technical Specifications”
section, start driving immediately;
175
DASHBOARD
AND CONTROLS
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
Apply the adhesive label in a position
clearly visible by the driver as a reminder
that the tyre has been treated with the quick re-
pair kit. Drive carefully, particularly on bends.
Don’t exceed 80 km/h. Don’t accelerate and brake
suddenly.
WARNING
❒
after driving for about 10 minutes stop and check the
tyre pressure again; pull up the handbrake;
If the pressure falls below 3 bars, do not
drive any further: the quick tyre repair kit
Fix & Go automatic cannot guarantee proper hold
because the tyre is too much damaged. contact
a Fiat Dealership .
WARNING
165-198 DUCATO LUM EN 12-02-2010 8:43 Pagina 175
To Next Page
Loading...
