FLIR BRICKSTREAM 3D Gen 2 - Page 74

Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
74
Note: The field must contain a valid email address on the
SMTP server.
7. From the Aggregation Level drop-down, select an aggregation level for the count report email (5
mins, 15 mins, 30 mins, 60 mins, and daily.)
Note: Depending on which option is selected, the sensor
sends you an email listing the metric data at the
aggregation level selected over the previous 24 hours. For
counting, if you select daily, the email contains a single
enter and exit count for the previous 24 hour period.
8. In the Delivery Time field, enter the time (in 24 hour format) at which the sensor should send the
email. The aggregate email contains data from midnight to midnight during the previous
calendar day. For example, if the Delivery Time is set for 18:00, the sensor sends the count data
for the previous day at 6 PM every day.
9. If your SMTP server requires an authentication password, click the Authentication switch to ON,
otherwise skip to next step.
The Username and Password fields become active.
a. In the Username field, enter the username for your SMTP Server.
b. In the Password field, enter the password for your SMTP Server.
10. Click Test Settings. A test email is sent to the email address entered in the Recipient email
address field.
A confirmation message appears.
11. Click Save. A confirmation message appears.
Note: If you receive an error message, see
Troubleshooting.
12. If possible, check the recipient's email to ensure that the test email arrives.