Fostex DMT-8VL - Page 144

DMTSvl Owner's Manual (MMC/FEX Ust/Maintenance/Speciflcatlons)
13 44 (<on/off>): click on/otf command
The command for setting the metronome on/off of D-80/DMT~8 vcr2.0/DMT'8 vl. When
ON Is set, the metronome signal will be fed to the track 8 output (analog output only) of
D-80/DMT-8 ver2.0/DMT-8vL
The Status Request Command
22 21: loop operation status request
The command inquiring the loop operation mode setup status.
D-80/DMT-8 vcr2.0/DMT-8n will reply with "32 2J (<loop op.mode-12>)."
22 22: loop on/otf status request
The command inquiring the loop on/ofT (-ON/OFF of AUTO RETURN) setup status.
D-80/DMT-8 ver2.0/DMT-8\z will reply with "32 22 (<on/off>)”
22 28: post locate status request
The command Inquiring the post locate mode (ON/OFF of AUTO PLAY) setup status .
D-80/DMT-8 ver2.0/DMT-8vi will reply with "32 28 (<post locate modc>)'\
22 20: auto rec status request
The command inquiring the auto rec mode setup status and this is replied by "32 2D
(<edit message>). * Reply from D-80/DMT-8 ver2.Q/DMT-8vi against this status request
will be cither one of the following:
ccdit messago -05; Possible to undo rehearsal mode.
-06; Possible to undo take mode.
-25; Impossible to undo rehearsal mode.
-26; Impossible to undo take mode.
-72: off
22 41: lock status request
The command inquiring the slaw on/off setup status and (he lock status.
D-80/DMT-8 ver2.0/DMT-8\r will reply with "32 41 (<lock status>)."
22 45: copy dip atatus request
The command inquiring the clipboard condition. If there is a copy paste data in the
clipboard, D-80/DMT-8 wr2.0/DMT-8n will reply with "32 45 (<edit message-01 >)" If
data in the clipboard is for mow paste or there is no valid data in it, it will reply will "32
45 (<edit message-14 (void dataf>). m
22 46: copy paste status request
The command inquiring execution status of copy paste editing.
When this command is received, D-80/DMT-8 wr2.0/DSfT 8vi will reply with either "32
46 (<edlt message-02xmmc time>)" or "32 46 (<edlt message-0O>)." <mmc time>
indicates unprocessed time until completion.
22 47: erase status request
The command inquiring execution status of erase.
When this command is received, D-&0/DMT-8 ver2.0/DMT-8Vlwill reply by either "32 47
(*edit message-02 ><mmc time>)" or "32 47 (<edlt message=00>)." <mmc time> indicates
unprocessed time until completion.
144