Fostex DMT-8VL - Page 18

DMT-8VL Owner's Manual (Names and Functions)
To exit edit mode, press the EXIT/NO key, DISP SEL key. or STOP button.
/ ■■ ■ “ — — ■
• Refer to page *W tor more iofbmwrtcn about r* cflpboard
| • Refer to page *7 T tor more infOmtafoo about Auto Punch inOue rooonang.
I • Refer to page "W lor mora informaaor atcut Auto Return
20. A uto Return Start key [AllTO RTN START)
This key stores the Start point for Auto Return or Auto Repeat. Pressing the
RECALL key, then this key (or pressing only this key) will display data currently
stored at this key. and put the unit into Edit mode.
If you press the STORE key. then this key after editing, the edited value will be
stored at this key. Data stored at this key can be used as a locator.
When you turn ofT the power to the DMT-Bvu the memory will be set to the factory
default value.
Refer to paga “AT tor mora Mom** about Auto Ratom and Auto Repeat I
21. A uto Punch In key [AUTO PUNCH IN]
This key stores the Punch In point for Auto Punch In/Out recording. Pressing the
RECALL key. then this key (or pressing only this key) will display data currently
stored at this key. and will place the unit In Edit mode.
If you press the STORE key, then this key after editing, the edited value will be
stored at this key. In addition to storing a Punch In point, this key can store the
paste start point, erase start point, and cut start point. Data stored at this key can
be used as a locator.
When you turn off the power to the DMT-8 vl. the memory will be set to the factory-
default value.
22. A uto Punch Out kay [AUTO PUNCH OUT]
This key stores the Punch Out point for Auto fanch lo/Out recording. Pressing the
RECALL key, then this key (or pressing only this key) will display data currently
stored at this key, and wtU place the unit In Edit mode.
If you pressing the STORE key. then this key after editing, the edited value will be
stored at this key. In addition to storing a Punch Out point, this key can store the
erase end point Data stored at this key can be used as a locator.
When you turn off the power to the DMT-Svu the memory will be set to the factory
default value.
23. A ulo Return End key [AUTO RTN END]
This key stores the End point for Auto Return or Auto Repeat. Pressing the
RECALL key, then this key (or pressing only this key) will display data currently
stored at this key, and will place the unit Into Edit mode.
If you press the STORE key, then this key after editing, the edited value will be
stored at this key. Data stored at this key can be used as a locator.
When you turn off the power to the DMT-Rvu the memory will be set to the factory
default value.
* Refer to peg* *88' tor more riermatton about Auto Rebjm and Auto Repeal, j
18