Fostex DMT-8VL - Page 19

DSfT-8vi Owner's Manual (Names and Functions)
24. Redo key [REDO]
Pressing this key after you press the UNDO key lets you to restore the status
obtained before you undo recording or editing. This key Is activated only when
the recorder transport section is stopped.
r ■ Re** to pagea "82, 98, 103, 106 and tor ta r more ntonr &co at*rji tne Fl$do openHoiv ]
25. Undo key [UNDO]
After using an edit function such as Paste, Erase, or Cut. or after auto punch In/out
recording, pressing this key will restore the previous status obtained before editing
or recording. This key is activated only when the recorder transport section is
stopped.
f Ret* to page* *82. M, 103,106 and 1QT tor mom rrtorTTweoo afrem fie Itodo operaPoo J
26. E rase key [ERASE]
This key has two functions: the Erase function, which erases data (creates silence)
within a specified region on the readied track. The other is the Cut function, which
cuts data from the region beginning at the specified point. Pressing this key when
all tracks are ready will activate the Cut function. Pressing this key while one or
more tracks arc safe will activate the Erase function.
A region to be erased is defined between the Auto Punch In point and the Auto
Punch Out point. A region to be cut is defined only by the Auto Punch In point.
This Cut operation requires only the start point of the region to be cut, that is, the
Auto Punch In point 9
Specify the area to be erased, using the Auto Punch In/Out points and the RECORD
TRACK select key. To use the Cut function, set all tracks to the ready condition, and
set the start point of the data to be cut as the Auto Punch In point.
This key is activated only when the recorder transport section is stopped.
(•A*far to page ’W tof more rtormatton about the E rasa.Cut oparaicc
27. J og/Shuttle dial
Jog dial (inside):
If you turn the jog dial when the recorder is stopped, you can perform jogging
(forward and reverse digital audio scrubbing), without altering the audio
quality. In edit mode, turning the Jog dial will incrcase/decrease the value.
In Setup mode, using the )og dial allows you to set the parameters.
Shuttle dial (outside):
The shuttle dial is used for the forward and reverse cueing at ♦ /•!, 2, 3, 5,9,
12. or 20 times speed. In edit mode, it Is used to move around the digits.
• Refer topage* ir and “Wtormocetnfematanaboutthe eating tho mewydata |
• Refer to page 10f lor more rrtymafton about Sotup mode __J
28. H ard disk access LED
This LED lights up or blinks when the hard disk is writing or reading data.
<CAUT10N>
Do net tom the pow* off while ta LH) 4 II or Wnterg Otherwise, toe data in the herd
d nk may be damaged
19