S8 WORK 2
Entry with Enter line 1 blinks
Change with numerical keyboard
0-999 SERVICE STAMP
000 WORK 2
S9 WORK 3
Entry with Enter line 1 blinks
Change with numerical keyboard
0-999 SERVICE STAMP
000 WORK 3
S10 WORK 4
Entry with Enter line 1 blinks
Change with numerical keyboard
0-999 SERVICE STAMP
000 WORK 4
S11 WORK 5
Entry with Enter line 1 blinks
Change with numerical keyboard
0-999 SERVICE STAMP
000 WORK 5
PRESS KEY
WRITE COFFEE
Write cofffee transfers the settings to
the coffee machine.
Navigate with cursor keys.
Transfer data to coffee
machine. If successful, data in
Terminal are deleted.
PLEASE WAIT
TERMINAL è COFFEE
ESC = Exit Service stamp mode. TERMINALREADY
DATA LOADED
Possible mistakes:
No connection ERROR
WRITEAERROR
Stamping not complete. ERROR
STAMP INVALID
Wrong device type e.g. F700 Test1 not allowed F700 TEST 1
INVALID
If the ESC button pressed before
writing to the coffee machine <<Write
coffee>>-key , the settings read in are
lost.
The identification number (Diagnosis No.) cannot be changed. This is firmly embedded in
the Terminal3000. The number is written into the service stamp. The following criteria must
be met in order to write a service stamp:
• date > 0.0.1990
• identification > 0
• major error ≥ 0
• work code 1 >0
There are 2 service stamps. The Terminal3000 overwrites the penultimate service stamp in
each case. This means that the last 2 service stamps are always present in the machine.
The service counter is written into the address of work code 6 and cleared.
After successful writing of the service stamp, the history bits are deleted.
To Next Page
Loading...
Need help?
General
