TD-100470.doc 7 / 32
1.1.6 Waiter key
This function only concerns use with a waiter lock on the coin checker input (X6). The selections
here are “without” and “Addimat”. When using a waiter lock, select “Addimat” (default is
“without”). CCI must also be set under “Setup” > “4 Coffee machine” with the install card.
1.1.7 CCI-UART
Here you have to define which UART to use for communication via the CCI protocol.
Choices: “CCI > UART1” and “CCI > UART0”
Default = CCI > UART1
1.1.8 command
The default value is two places after the decimal, since this applies to most countries. The setting
range is 0 to 3 decimal places. The decimal is only shifted. Five digits are always displayed.
Thus: 00000 or 000.00 etc. (no change in value)
Default = 2
Decimal places 0 .. 3
1.1.9 Timeout
This menu item determines the timeout that can be set on some machine types.
We make a distinction between two different types:
- F700 protocol (Saphira/Flair)
- If the coffee machine is set to Saphira or Flair (F700), it is the Saphira/Flair timeout. The user
can set the same timeout as on the Saphira/Flair; the collection system automatically uses
300 [ms] less to understand the signal just to be on the safe side.
- Timeout Saphira/Flair 0 .. 125 [s]
- CCI protocol (Evolution/Sinfonia etc.)
The TOPS timeout is configurable on the Inkasso3. If the coffee machine is set to CCI, then this
is the timeout for the validity of a preselected product. Please refer also to Section 2.3.1.
- Timeout CCI 5 .. 60 [s]
Example coffee machine = CCI
Timeout: Display Z2 5 - 60 [sec.] CCI
Default = 5 [sec.]
Example coffee machine = Saphira
Timeout: Display Z2 0 - 125 [sec.] F700
Default = 5 [sec.]
1.1.10 Loading
With this function you can permit or block loading the Franke Cash Card or another electronic
money medium (e.g. Legic Card) with a coin checker, bill reader or coin changer.
Default = NO (blocked)
To Next Page
Loading...
Need help?
General
