How to prevent paper curling in Fuji Xerox Document Centre 236?
To prevent paper curling in your Fuji Xerox All in One Printer: * Check that the paper is loaded correctly. Load paper in Trays 1, 2, 3 and 4 seam side up. * Load paper in the Tandem Tray Module and bypass tray seam side down. * Load custom media in the bypass tray.
How to remove streaks from Fuji Xerox All in One Printer output?
To remove streaks, solid or dotted lines, or spots from your Fuji Xerox All in One Printer output: * Clean the document glass, the CVT glass, the areas under the platen cover, the document feeder, and the paper guides. * If the machine has been idle for an extended period of time, or if the toner or drum cartridge is new, begin the job again. * Run the job using the document glass. * Reinstall the drum cartridge. * Check the quality of the document. Use [Border Erase] to remove lines and marks from the edges of the document. * Load fresh paper. * Check the humidity of the machine location.
How to adjust the darkness of the print on Fuji Xerox Document Centre 236 All in One Printer?
If the output from your Fuji Xerox All in One Printer is too light or too dark: * Load fresh paper. * Check the quality of the document. * Select [Lighten/Darken] on the touch screen. * Run off more prints until the copy quality improves. * Replace the drum cartridge.
Why Fuji Xerox All in One Printer does not accept documents into memory?
If your Fuji Xerox All in One Printer does not accept documents into memory: * Check with the System Administrator about available memory. * If the memory is almost full, print and delete unnecessary files.
What to do if Fuji Xerox Document Centre 236 All in One Printer displays a memory full error message?
If your Fuji Xerox All in One Printer displays a memory full error message: * Check with the System Administrator about available memory. * Divide the remaining pages of the job into several small jobs and run the job again.
How to fix Fuji Xerox Document Centre 236 All in One Printer that will not power on?
If your Fuji Xerox All in One Printer won't power on, try these steps: * Check the power cord. * Ensure the power switch is in the ON position. * Verify the RESET button on the back of the machine is not tripped (popped up); push it to reset. * Confirm the AC outlet is supplying voltage by connecting another appliance.
General| Brand | Fuji Xerox |
|---|---|
| Model | Document Centre 236 series |
| Category | All in One Printer |
| Language | English |
Provides critical safety instructions for operating the machine.
Introduces the machine's capabilities: Copy, Fax, Scan, E-mail.
Step-by-step guide for performing basic copying operations.
Covers fundamental copy settings like Reduce/Enlarge and Paper Supply.
Details settings for adjusting scanned image quality and layout.
Step-by-step guide for sending faxes and iFaxes.
Details core fax settings and image adjustments.
Outlines the steps for scanning documents.
Covers sending scanned documents via e-mail and managing addresses.
Explains saving scans to mailboxes or sending to servers via templates.
Details scan resolution, file format, and image quality adjustments.
Step-by-step guide for replacing drum and toner.
General steps for identifying and resolving faults.
Detailed instructions for clearing paper jams in various locations.
Addresses document jams and provides a table for common issues.
Lists and explains fault codes and error messages.
To Next Page