Rev. AV Page 24-41
67
48
GAD 29
P292
GPS/NAV/COM
GTN 6XX/7XX #1
S
29
ARINC 429 OUT 1A10
S
23
24
S
29
10
S
23
24
S
ARINC 429 OUT 1B
GPS/NAV/COM
GTN 6XX/7XX #2
67
48
ARINC 429 IN 1A
ARINC 429 IN 1B
ARINC 429 OUT A
ARINC 429 OUT B
ARINC 429 OUT 1A
ARINC 429 OUT 1B
ARINC 429 OUT A
ARINC 429 OUT B
ARINC 429 IN 1A
ARINC 429 IN 1B
P1004
P1001
P1001
P1004
GDU 4XX/37X
RS-232 IN 3 29
RS-232 OUT 3 13
S
GDU 4XX/37X (PFD)
P4X02/P3701
RS-232 IN 2 14
RS-232 OUT 2 30
S
7
ETHERNET IN 1A6
ETHERNET IN 1B
8
9
SEE NOTE 13
CONFIGURATION GUIDANCE
1. GTN 6XX/7XX #1 AND #2
A. ON THE ARINC 429 CONFIG PAGE
SET IN 1 SPEED TO "LOW"
SET IN 1 DATA TO "GDU FORMAT 2" (GTN V6.71 AND LATER)
SET OUT 1 SPEED TO "LOW"
SET OUT 1 DATA TO "GARMIN 429" (GTN V6.50 AND LATER)
SET OUT 1 DATA TO "GAMA FORMAT 1" WHEN "GARMIN 429" NOT AVAILABLE
SET SDI TO "LNAV 1" FOR GTN #1 AND "LNAV 2" FOR GTN #2
B. ON THE RS-232 CONFIG PAGE
SET CHNL 3 INPUT TO "MAPMX FORMAT 2" WHEN THIS FORMAT IS AVAILABLE
SET CHNL 3 OUTPUT TO "MAPMX" WHEN "MAPMX FORMAT 2" INPUT NOT AVAILABLE
SET CHNL 4 INPUT/OUTPUT TO "CONNEXT FORMAT 2" FOR GTN #1 WHEN USED
C. ON THE MAIN MAIN INDICATOR (ANALOG) CONFIG PAGE
SET SELECTED COURSE FOR VLOC TO "IGNORED"
D. ON THE VOR/LOC/GS ARINC 429 CONFIG PAGE
SET NAV RADIO TO "ENABLED"
SET TX SPEED TO "LOW"
SET SDI TO "VOR/ILS 1" FOR GTN #1 AND "VOR/ILS 2" FOR GTN #2
E. ON THE INTERFACED EQUIPMENT CONFIG PAGE
SET CROSS-SIDE NAVIGATOR TO "PRESENT"
2. G3X
A. ON THE GDU 4XX/37X RS-232 AND ARINC 429 CONFIG MODE PAGES
SET THE CONNECTED GDU 4XX/37X (PFD) RS-232 CHANNEL TO "MAPMX" FOR GTN #1
SET THE CONNECTED GDU 4XX/37X (PFD OR MFD) RS-232 CHANNEL TO "MAPMX" FOR GTN #2
SET THE CONNECTED GDU 4XX (PFD) RS-232 CHANNEL TO "GTN CONNEXT 2" WHEN USED
SET ARINC 429 TX 1 FORMAT TO "EFIS/AIRDATA FORMAT 1" AND "NAV 1 + 2"
SET ARINC 429 RX 1 FORMAT TO "GARMIN GPS" AND "NAV 1" FOR GTN #1
SET ARINC 429 RX 2 FORMAT TO "GARMIN VOR/ILS" AND "NAV 1" FOR GTN #1
SET ARINC 429 RX 3 FORMAT TO "GARMIN GPS" AND "NAV 2" FOR GTN #2 (IF APPLICABLE)
SET ARINC 429 RX 4 FORMAT TO "GARMIN VOR/ILS" AND "NAV 2" FOR GTN #2
IMPORTANT: GTN #1 AND #2 ARE DIFFERENTIATED IN THE G3X SYSTEM BY THE GDU 4XX/37X RS-232 PORT ASSIGNMENTS.
GTN #1 SHOULD ALWAYS BE CONNECTED TO A LOWER NUMBERED PORT ON THE PFD. GTN #2 CAN BE CONNECTED TO A
HIGHER NUMBERED PORT ON THE PFD OR TO ANY PORT ON THE MFD.
SEE NOTE 11
6 RS-232 OUT 3
25 RS-232 IN 3
6 RS-232 OUT 3
25 RS-232 IN 3
8 ETHERNET OUT 1A
9 ETHERNET OUT 1B
6
7 ETHERNET IN 1B
ETHERNET IN 1A
ETHERNET OUT 1B
ETHERNET OUT 1A
P1002
P1001
P1002
P1001
(PFD OR MFD)
P4X02/P3701
A429 TX 1A (AIR DATA) 24
A429 TX 1B (AIR DATA) 12
ARINC 429 RX 1A (GPS) 23
ARINC 429 RX 1B (GPS) 11
ARINC 429 RX 2A (NAV) 22
ARINC 429 RX 2B (NAV) 10
ARINC 429 RX 3A (GPS) 17
ARINC 429 RX 3B (GPS) 5
ARINC 429 RX 4A (NAV) 16
ARINC 429 RX 4B (NAV) 4
SIGNAL GROUND 34 44 RS-232 GND 3/4
S
S
S
S
S
S
S
S
S
SIGNAL GROUND 35 44 RS-232 GND 3/4
MAPMX INTERFACE
MAPMX INTERFACE
RS-232 IN 4 23
RS-232 OUT 4 40
S
5 RS-232 OUT 4
24 RS-232 IN 4
SIGNAL GROUND 36 44 RS-232 GND 3/4
S
CONNEXT INTERFACE
GDU 4XX (PFD)
NOTE: THIS INTERFACE EXAMPLE DRAWING IS NOT SUFFICIENT FOR INSTALLATION OF A GTN 6XX/7XX
SERIES PRODUCT. PLEASE REFERENCE THE APPROPRIATE INSTALLATION DOCUMENTATION FOR THE
GTN 6XX/7XX SERIES UNIT FOR COMPREHENSIVE INSTALLATION AND CONFIGURATION INFORMATION.
SET IN 1 DATA TO "EFIS FORMAT 2" WHEN “GDU FORMAT 2” IS NOT AVAILABLE
NOTE 1: BEGINNING WITH GDU 4XX SOFTWARE V8.91, TRANSITION TO APPROACH MAY BE ENABLED ON THE GTN 6XX/7XX
NAVIGATOR.
To Next Page
Loading...
