Garmin G3X - 32.2.6 GSA 28; 32.2.6.1 GSA 28 is removed; 32.2.7 GAD 29; 32.2.8 GMC 30 X;507

190-01115-01 G3X™/G3X Touch™ Avionics Installation Manual
Rev. AV Page 32-7
32.2.6 GSA 28
32.2.6.1 GSA 28 is removed
No additional action is required when a GSA 28 is reinstalled or replaced. The correct GSA 28 software
version and autopilot configuration settings will automatically be loaded from the GDU.
NOTE
A removal adapter (GPN 011-03158-00) is provided (with each GSA 28 connector kit) that
can be used when a GSA 28 is removed. The adapter keeps that node on the CAN bus in
the same state as when the servo was connected (either terminated or un-terminated). The
adapter also allows trim signals to pass through when the servo is removed.
32.2.7 GAD 29
No additional action is required when a GAD 29 is reinstalled or replaced. The correct GAD 29 software
version and ARINC 429 configuration will automatically be loaded from the GDU.
32.2.8 GMC 30X/507
No additional action is required when a GMC 30X/507 is reinstalled or replaced.