190-01115-01 G3X™/G3X Touch™ Avionics Installation Manual
Rev. AV Page 30-91
d) Press the Autopilot button.
e) Select the Roll Tab and highlight the Roll Servo Gain entry.
f) Adjust the servo gain so the aircraft properly responds to the roll guidance from the flight
director
i. Overpower the autopilot to fly away from the current flight director commanded roll
ii. Release controls and monitor autopilot response and closure back to commanded roll
iii. Set the SERVO GAIN higher to make the autopilot more aggressive
iv. Set the SERVO GAIN lower to make the autopilot less aggressive
2. The Roll Tab has additional expert settings that can be adjusted to achieve the desired lateral mode
performance. These settings are detailed in Section 30.4.10.10
and should only be adjusted after
studying the description to properly understand their effect on the roll servo. See preceding note
to
access the expert settings.
To Next Page
