190-01115-01 G3X™/G3X Touch™ Avionics Installation Manual
Rev. AV Page 30-98
3.Engage YD by pressing the YD button on the GMC Mode Controller as ball
swings through the center
4.Set SERVO GAIN so the established yaw body rate from the yaw doublet is
properly dampened out
a.Set the SERVO GAIN higher to make the yaw damper more aggressive
b.Set the SERVO GAIN lower to make the yaw damper less aggressive
The yaw servo has additional advanced and expert settings that can be adjusted to achieve the desired yaw
damping performance. These settings are detailed in Section 30.4.10.10
and should only be adjusted after
studying the description to properly understand their effect on the yaw servo. See preceding note
to access
the advanced/expert settings.
To Next Page
