190-01115-01 G3X™/G3X Touch™ Avionics Installation Manual
Rev. AV Page 30-150
VNE Alert–Enables/Disables VNE exceedance audio alert.
AFCS Attention Tones–Enables/disables AFCS attention tones.
AOA Alert–Enables/disables AOA Alert tone. Volume can be individually set for this alert by touching
Volume. The far left position of the volume slider sets the volume to AUTO. If set to AUTO, the volume
will be slaved to the Master Alert Volume.
Altitude Alert–Enables/disables the Altitude Alert tone. Volume can be individually set for this alert by
touching Volume. The far left position of the volume slider sets the volume to AUTO. If set to AUTO, the
volume will be slaved to the Master Alert Volume.
AOA Alert Mode - When set to Stall Awareness, the system will audibly alert the pilot when the AOA
indicator enters the caution range and will beep progressively faster as AOA is increased towards a stall. A
constant tone indicates a stall. When set to Approach + Stall Awareness, the pilot is audibly alerted in the
same manner, however the alerts begin when at or above the approach target calibration point and increase
progressively faster until a constant tone is reached at the point of stall.
Message Tone–Controls the volume level (settings 1-10, or OFF) of message tones (Airspace Advisory
Messages, Approaching VNAV Target Altitude Message, etc.). Volume can be individually set for this
alert by touching Volume. The far left position of the volume slider sets the volume to AUTO. If set to
AUTO, the volume will be slaved to the Master Alert Volume.
Minimums Alert–Enables/disables the Altitude Minimums tone. Volume can be individually set for this
alert by touching Volume. The far left position of the volume slider sets the volume to AUTO. If set to
AUTO, the volume will be slaved to the Master Alert Volume.
Miscompare Alert - Enables/Disables ADAHRS Miscompare Audio Alerts.
Takeoff Alert–Enable/disables takeoff safe altitude alert. Volume can be individually set for this alert by
touching Volume. The far left position of the volume slider sets the volume to AUTO. If set to AUTO, the
volume will be slaved to the Master Alert Volume.
VNAV Alert–Enables/disables VNAV TOD proximity alert. Volume can be individually set for this alert
by touching Volume. The far left position of the volume slider sets the volume to AUTO. If set to AUTO,
the volume will be slaved to the Master Alert Volume.
Radio AGL Alert - Audio alerts can be configured to provide callouts for various altitude ranges, or
disabled entirely. Selecting "All" will play all available Radio or Radar altitude callout alerts.
Engine/Airframe Alert Mode - Tone Only/Tone + Voice. If Tone + Voice is selected, a spoken audio clip
will be played when certain engine/airframe CAS messages are generated.
To Next Page
Loading...
