GE Optima XR646 - Page 462

Appendix B: Specifications
5495975-1EN Rev.9 B-3
© 2013-2017 General Electric Company. All rights reserved.
– Minimum Height of Tabletop: ≤500mm (Allowable Deviation: ±10mm)
– Tabletop Travel Range:
 Horizontal Lateral: 280mm ±10mm
 Horizontal Longitudinal: 680mm ±10mm
 Standard Table (GCTBL-C6)
– Height from Tabletop to floor: 525mm~825mm (Allowable Deviation: ±10mm)
– Table Detector Travel Range: 510mm (Allowable Deviation: ±10mm)
– Minimum Height of Tabletop: ≤525mm (Allowable Deviation: ±10mm)
– Tabletop Travel Range:
 Horizontal Lateral: 220mm ±10mm
 Horizontal Longitudinal: 990mm ±10mm
 Digital Wallstand (5181666/5136848-2/GCWS-C1/GCEWS-C1/NBS2100)
– Digital Detector:
 Detector Vertical Travel Range along the Wallstand Column: 1500mm ±10mm
 Detector Negative Rotation Range: -20° ~0° (Allowable Deviation: ±2°)
 Detector Positive Rotation Range: 0°~90° (Allowable Deviation: ±2°)
 Manual Wallstand (GCMWS-C6)
– Digital Detector:
 Detector Vertical Travel Range along the Wallstand Column: 1500mm ±10mm
 OTS:
– OTS Column Vertical Travel Range: ≥1500mm (Allowable Deviation: ±10mm)
– OTS Column Rotation Range: -180° ~ +180° (Allowable Deviation: ±2°)
– X-Ray Tube Rotation Angle around the lateral arm: -180° ~ +135° (Allowable Deviation: ±2°)
– Collimator Rotation Angle around the vertical arm: -90° ~ +90° (Allowable Deviation: ±2°)
– Lateral Travel Range: ≥856mm
– Longitudinal Travel Range: ≥2805mm
 Braking Force
– Digital Table: The braking force of the linear movement ≥100N
– Standard Table: The braking force of the linear movement ≥100N