GE Senographe DS

Chapter 9 Page no. 1476
JC-DR-A-318.fm
GE Healthcare Senographe DS
Revision 1 Service Information and Procedures Class A 2385072-16-8EN
Job Card D/R A318 - LCD Monitor
6. Unscrew the screw (4) (screwdriver) which secures the monitor cable protecting plate (5) and remove
the cable protecting plate.
7. Connect the ground cable (6) (screwdriver).
8. Connect the video connection as follows:
• On V2 Control Stations, connect the five BNC cables. Insert a BNC T Adapter and a 75 Ohm BNC
Terminator between the black cable and the monitor connector.
4
5
5
4
Sisfle Arm
Ergotron B Arm
6
8
Red
Green
Blue
Grey
Black plus BNC T Adapter
and BNC Terminator
7