GE Senographe DS User Manual

GE Healthcare Senographe DS
Revision 1 Service Information and Procedures Class A 2385072-16-8EN
Job Card ELE A021 - Networking Connection and Configuration
Page no. 637 Chapter 7
JC-ELE-A-021.fm
nge0 option, and press the <F2> key to continue.
10. At the Confirmation Information for nge0 screen, ensure that the correct information appears for the
nge0 network interface, and press the <F2> key to continue.
A screen indicating a delay may appear while the settings for the nge0 network interface are being
stored.
11. At the Configure Security Policy screen, ensure that No is selected for the Configure Kerberos Secu-


Default Route for nge0

Detect one upon reboot

Specify one


To specify the default route, you can let the software ...



.........................
Set the Default Route for nge0
--------------------
None

X
X



Networked:

> Confirm the following information. If it is correct ...



.........................
Confirm information for nge0
Yes
Use DHCP:
No
Host name:
XXXXXX
IP address: N.N.N.N
System part of a subnet:
Yes
Netmask:
N.N.N.N
Enable IPv6:
No
Default Route:
None
Just a moment

GE Senographe DS Specifications

General

Brand	GE
Model	Senographe DS
Category	Medical Equipment
Language	English