Chapter 7 Page no. 658
JC-ELE-A-021.fm
GE Healthcare Senographe DS
Revision 1 Service Information and Procedures Class A 2385072-16-8EN
Job Card ELE A021 - Networking Connection and Configuration
9-2-3 Disabling Auto-negotiation at Boot Time via the S93route File
To make this setting permanent (done at each boot), you can put these ndd -set command lines in the
/etc/rc2.d/S93route file (with or without a route). Each time the system boots the information in the
/etc/rc2.d/S93route file is processed automatically. This ensures that the router is automatically declared
(if the lines router declaration exist) and the network interface eri0/nge0/e1000g0 is automatically run-
ning in auto negotiation=no mode with the maximum speed supported by the hospital switch. To do this,
use the following steps:
1. From behind the Browser, launch a command window (see Launching a Command Line Window on
page 120).
A command window appears with an ADS prompt.
2. Log in as root as follows:
a. At the ADS prompt enter:
su -
b. When requested to specify the root password, enter:
operator
3. Ensure that the /etc/rc2.d/S93route file exists, by entering:
touch /etc/rc2.d/S93route
4. Allow the /etc/rc2.d/S93route file to be written to, by entering:
chmod ou+w /etc/rc2.d/S93route
5. Exit as root user to return to sdc user, by entering:
exit
You are returned to the command prompt as sdc user.
6. Open the /etc/rc2.d/S93route file with the textedit command by entering:
textedit /etc/rc2.d/S93route
The /etc/rc2.d/S93route file appears in an X-Windows based TextEdit application window.
To Next Page
Loading...
Need help?
General
