GE Sievers Innovox - Figure 56: Configuring the Factor Name

GE Analytical Instruments ©2016 149 of 270 DLM 68100-09 EN Rev. A
Chapter 6: Analyzer Operation
8. Press the Factor Name button and use the alpha/numeric keypad to type a name for the conversion
factor (Figure 56
).
Figure 56: Configuring the Factor Name
9. Press the Save button to save the conversion factor name and return to the Factor screen.
10. Press the Back button to access the other available conversion factors.
11. Repeat steps 3
through 10 for each conversion factor to configure.
Each configured conversion factor now appears when setting up Stream measurements or Grab
measurements (Figure 57
), as described earlier in this chapter. To apply a conversation factor, press its
button from this screen.
Figure 57: Using a Conversion Factor