GE Analytical Instruments ©2016 75 of 270 DLM 68100-09 EN Rev. A
Chapter 4: Installation
Figure 3: Attaching Mounting Brackets on the Analyzer
To mount the Analyzer on the Mounting Stand, attach the two mounting brackets to the top and bottom of the
Analyzer as shown in Figure 3
. The brackets are held on by six 5/16-18 flange nuts. Insert the bracket with the
studs through the flange that is welded onto the instrument case. Tighten the six flange nuts.
Next, lift the Analyzer onto the Mounting Stand. Secure the Analyzer on the Mounting Stand (refer to Figure 4
).
Lock the Analyzer onto the Mounting Stand, using four 2 in. 10-32 screws on both the top and bottom mounting
brackets you attached to the Analyzer. Tighten the screws down against the inside surface of the cross
members of the Mounting Stand. By friction, these screws keep the instrument from moving around.
NOTE:
We recommend when lifting the instrument that you use a two-person lift. OSHA
standards require protecting employees from injury. This instrument weighs over
40 lbs. It is the policy of GE to require a two-person lift for items weighing over 40 lbs.
To Next Page
Loading...
