GE Analytical Instruments ©2016 156 of 270 DLM 68100-09 EN Rev. A
Chapter 6: Analyzer Operation
Setting Up Input and Output (I/O)
The I/O Tab
Connecting the Analyzer to a Network Via Ethernet
The Analyzer can be connected to your network or directly to a personal computer via an Ethernet cable. If you
connect the Analyzer to your network, use a standard Ethernet cable. If you connect the Analyzer directly to a
personal computer, use an Ethernet crossover cable.
Configuring the Analyzer’s IP Address
You must configure the Analyzer’s Internet Protocol (IP) settings for use in connecting the Analyzer to a
computer network or directly to a computer.
To configure the Analyzer’s IP Address
1. Select the I/O tab, and then press the IP Configuration button. The Configuration screen appears.
Figure 61: IP Configuration Screen
NOTE:
Consult with your Information Technology group to determine the best configuration for your
networking environment.
To Next Page
Loading...
