GE Analytical Instruments ©2016 193 of 270 DLM 68100-09 EN Rev. A
Chapter 8: Maintenance
Figure 82: Replacing the NDIR Filter
Entering Consumables Installation Information
After you have installed a new consumable item, enter the installation date so the Analyzer can keep track of
usage and alert you when consumables are nearing the end of their life.
To enter consumables installation information
1. Select the Maintenance tab.
2. Press the Consumables button.
3. Press the Reset Pump or Reset Tubing button for the item you have installed.
Other Maintenance Tasks
Other maintenance tasks are performed only when required and as indicated in this section.
Sparger Outlet
Reactor Outlet
Gas-Liquid
Separator (GLS)
Waste
NDIR Outlet
NDIR Filter
Carrier Gas
To Next Page
Loading...
