GE Analytical Instruments ©2016 72 of 270 DLM 68100-09 EN Rev. A
Chapter 4: Installation
• Sievers InnovOx On-Line TOC Analyzer Operations and Maintenance Manual (Available for download from
www.geinstruments.com
).
• Accessories included:
• Reagent, dilution water, check standard tubes (and tubing weights and fittings)
• Vial port tube and fittings
•Waste tube
• 5/32 in. Allen
®
wrench (hex key), for reactor valve
• Squeeze bottle
• Metal dowel (for NDIR leak testing)
• Spare reactor seals (2)
• 3.5 gal carboys for acid and oxidizer
• 1.0 gal carboy for check standard
• 5 gal carboy for dilution water
• Tubing for sample inlet (10 ft.)
• PVC sample control valves (2 or 5, depending on the Analyzer configuration)
• USB flash memory drive
• Two (2) PVC conduit connectors (“strain relief” hubs) for conduit wiring
• Sealing washers for PVC conduit connectors
• Terminal ring for AC conduit ground wire, 16-14 AWG
• Ferrites for I/O cable
• Ethernet cables (one cross-over and one straight-through)
• Grounding wrist strap
• Level sensors for reagents, dilution water, and check standard (if Fail Safe Accessory was ordered)
• Mounting Stand mounting hardware for Analyzer and Filter Panel (if Mounting Stand Accessory was
ordered)
•Extra tubing
•Extra fittings
• Certificate of Performance
To Next Page
Loading...
