GE HEALTHCARERAFT VOLUSON E8 / VOLUSON E6
D
IRECTION KTD102576, REVISION 7 DRAFT (AUGUST 23, 2012) SERVICE MANUAL
3-40 Section 3-7 - Printer Installation
3-7-3 Printer Installation manually (cont’d)
13.)Assign a name, decide if printer should be used as default printer and confirm with NEXT
.
NOTE: If the “Printer Sharing” window appears, select ‘Do not share this printer‘ and confirm with NEXT
.
14.)The “Complete the Add Printer Wizard” window appears on the screen.
15.)Complete the manual Printer Installation with the FINISH
button.
NOTE: If the message “The software you are installing for this hardware has not passed Windows ....” appears,
click CONTINUE ANYWAY
.
16.)Close all open windows, close the “System Setup” with SAVE & EXIT
and restart the system
(turn off and on the system).
Figure 3-38 Assign name
Figure 3-39 Complete manual Printer Installation
!! NOTICE:
After boot up of the system, verify the correct settings in the printer “Properties”,
see: Section 3-7-4 "Adjustment of Printer Settings" on page 3-41.
Afterwards assign the Printer to the remote keys P1
, P2, P3 and/or P4,
see: Section 3-7-5 "Remote Control Selection" on page 3-48.
To Next Page
Loading...
