gefran TPD32-EV-...-4B - General Unlocking of the Password; Operating the Drive Via the Keypad

—————— Instruction manual ——————
111
General unlocking of the password
CONFIGURATION
Pword 1: Enabled
Pword 1: Enabled
Password 0 0 0 0 0
Return without changes
0 ... 9
9 ... 0
CONFIGURATION
Pword 1: Disabled
Pword 1: Enabled
Password Wrong
Pword 1: Disabled
Password 0 0 0 0 0
Password ok
Password incorrect
E
E
CANC
+
-
- SelecttheparameterPword1(=Password1)intheCONFIGURATIONmenu.
- Whenthepasswordisenabled,themessage“Pword1:Enabled”appears
- PressEtocallthevalue00000withthelastdigitashing.Thevaluechangedisalwaysthedigitthatis
ashing.Thevalidpasswordmustbere-enteredinordertounlockit.
- Increasethenumericalvaluewith+
- Reducethenumericalvaluewith-
- Selectthenextdigitleftwith
- Selectthenextdigitrightwith
- ConrmthepasswordbypressingE.Themessage:Pword1:Enabledwillthenappearforashorttime.
- TheexistingpasswordisindicatedintheCONFIGURATIONmenuviathe“Pword1:Enabled”message.
- PresstheCANCkeyinordertoaborttheentryofthepasswordifrequired.
- IftheincorrectpasswordisenteredandthentheEkeypressed,themessage“Passwordwrong”willappear
andthekeypadwillreturntotheCONFIGURATIONmenuwiththedisplay“Pword1:Enabled”
note!  TheSave parameterfunctionmustbeusedtosavethepasswordifthepassworditselfmust
notonlybedisabledbutcompletelyunlocked.
5.1.5 Operating the drive via the Keypad
Inordertooperatethedriveviathekeypad,thefollowingsettingsmustbedone:
STARTUPandCONFIGURATIONmenu  SetMain commands = Digital
MENUCONFIGURATION   Set Control Mode = Local
- Thehardwareenablesonterminals12...15arealsoactivewhenthedriveisoperatedviathekeypad.This
means,forexample,thatthesignalatterminal13mustalsobepresentforstartingthedriveinaddditionto
thecommandviathekeypad.
- Ifthedriveisstoppedviathekeypad,itcanberestartedsimplybypressingtheStartKey.
- Ifthestopwascausedbyremovingthevoltagesignalonterminal13,boththesignalatterminal13and
thecommandviathekeypadarenecessarytorestartthedrive.Thesignalattheterminalsmustbepresent
beforegivingthekeypadcommand.
- ThesameappliesaccordinglytotheenablingofthedriveviatheEnable driveparameter.