EasyManua.ls Logo

gefran TPD32-EV-...-4B - Upon Delivery Inspection Procedures; Storage, Transport; Device Setting

gefran TPD32-EV-...-4B
504 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
—————— TPD32-EV ——————
24
2.2 UPON DELIVERY INSPECTION PROCEDURES
Storage, Transport
AhighdegreeofcareistakeninpackingtheconvertersoftheTPD32-EVseriesandpreparingthemfordelivery.
Theyshouldonlybetransportedwithsuitabletransportequipment(seeweightdata).Observetheinstructions
printedonthepackaging.Thisalsoapplieswhenthedeviceisunpackeduptowhenitisinstalledinthecontrol
cabinet.
Ondeliverycheckthefollowing:
- thepackagingforanyexternaldamage
- whetherthedeliverynotematchesyourorder.
Openthepackagingwithsuitabletools.Checkwhether
- anypartsweredamagedduringtransport
- thedevicetypecorrespondstoyourorder
Intheeventofanydamageorofanincompleteorincorrectdeliverypleasenotifythesalesofcesresponsible
immediately.
Thedevicesshouldonlybestoredindryroomswithinthetemperaturerangesspecied.
note! Acertaindegreeofmoisturecondensationispermissibleifthisarisesfromchangesintem-
perature(seesection3.1,“PermissibleAmbientConditions”)Thisdoesnot,however,apply
whenthedevicesareinoperation.Ensurealwaysthatthereisnomoisturecondensationin
devicesthatareconnectedtothepowersupply!
2.2.1 Device setting
TheconvertersoftheTPD32-EVseriescanoperateconnectedtoanACinputthree-phasevoltagefrom230Vto
690V.Insidethisvoltagerangethedevicesettingiscarriedoutonthebasisofthemotorratedcurrent.Therefore
theconverterratedcurrentmustbehigherorthesameasthemotorratedone.
Ifanoverloadisnecessary,thesettingiscarriedoutaccordingtotheexamplementionedinsection6.14.6,
“Overloadcontrol”,sothattheovercurrentmustnotbesuppliedinacontinuativewayfromthetypeofthe
chosenconverter.
note! Areductionfactorshouldbeconsiderediftheconverterisinstalledataltitudesofover3,300
feet(1000m)abovesealevelandathighertemperatures(seesection3.1,“Permissibleambi-
entconditions”).

Table of Contents

Related product manuals