gefran TPD32-EV-...-4B - Encoder; Tachometer

—————— Instruction manual ——————
59
2.6.2 Encoder / Tachometer
Theencodersandthetachometersgivethespeedfeedbacktotheregulation.Theyhavetobemountedonthe
motorshaftwithjointswithoutgaps.Thebestregulationresultsarepossiblebyusingincrementalsinusoidal
encoders;itisalsopossibletousedigitalincrementalencodersortachogenerators,seesection,“Accuracy”.
Features:
Sinusoidal encoder
 maxfrequency  150kHz
 numberofpulsesperrevolution min 600
   max 9999
 channel  two-channel
 supply  +5V(internalsupply)
 loadcapacity  >8.3mAppeachchannel
Digital encoder
 maxfrequency  150kHz
 numberofpulsesperrevolution min 600
   max 9999
 channels  two-channel,withcomplementaryoutputs
 supply  +5V/15...24V(externalsupply)  
   +24V(internalsupply)
 loadcapacity  >4.5mA/6.8...10.9mAeachchannel
Analog tachometer
 forTPD32-EV-...-2B dynamo
 forTPD32-EV-...-4B dynamo(fortherotationdirectioninversion,thesup-
pliedvoltagepolarityshallinvert)
 maxvoltageatmaxspeed 22.7/45.4/90.7/181.6/302.9V,dependingonthe
dipswitchS4setting
 current 8mA,fullscale
Tacho voltage
input (V)
S4-1
S4-8
S4-2
S4-7
S4-3
S4-6
S4-4
S4-5
22.7 ON ON ON ON
45.4 ON ON ON OFF
90.7 ON ON OFF OFF
181.6 ON OFF OFF OFF
302.9 OFF OFF OFF OFF