gefran TPD32-EV-...-4B - Field Circuit; Field Circuit TPD32-EV-FC Version; Output Voltage

—————— Instruction manual ——————
33
Fieldcurrentfullscalevaluesotherthanthoseshowninthetablecanbeobtainedbyconnectingaresistorofa
suitablevaluebetweenterminalsLAandLBontheregulationcard.Thisvalueiscalculatedasfollows:
Type of field circuit Resistance RlA-lb [Ohm] Dip-switch S14
40A R
la-lb = 3333,3 / field current f.s.v. [A]
All OFF
70A R
la-lb = 1666,6 / field current f.s.v. [A]
Output voltage
ThebelowmentionedoutputvoltagestakeintoaccountanACinputundervoltagewithinthestatedtolerance
limitsandavoltagedropof4%duetotheinsertedACinputreactors.Itisthesameastheratedarmaturevoltage
suggestedfortheconnectedmotor.
• Armature circuit
Table 2.3.3.5: Armature circuit output voltages
AC input voltage
(terminals U / V / W)
Max output voltage U
dN
(terminals C/D)
Two quadrant converter Four quadrant converter
3 x 230 V ±10 % 260 V 240 V
3 x 400 V ±10 % 470 V * 420 V *
3 x 440 V ±10 % 530 V 460 V
3 x 460 V ±10 % 560 V 480 V
3 x 480 V ±10 % 580 V 500 V
3 x 500 V ±10 % 600 V 520 V *
3 x 575 V ±10% 680 V 600 V
3 x 690 V ±10% 810 V 720 V
* VoltagemeasuredasDIN40030(09/93)
• Field circuit
Table 2.3.3.6: Field circuit output voltages
AC input voltage
(terminals U1 / V1 )
Output field voltage U
FN
** (terminals C1 / D1)
Fixed field Adjustable field
1 x 230 V ±15 % 200 V * 200 V *
1 x 400 V ±15 % 310 V * 310 V *
1 x 460 V ±10% 360 V 360 V
* VoltagemeasuredasDIN40030(09/93)
** Themaxeldvoltageisequalto0.85xU
LN
• Field circuit TPD32-EV-FC version
Table 2.3.3.7: Field circuit output voltages TPD32-EV-FC
AC input voltage
(terminals U / V /N )
Max Output field voltage U
dN
** (terminals C / D)
2B 4B
3 x 110 V - 115 V
3 x 200 V - 210 V
3 x 230 V 260 V 240 V
3 x 400 V 470 V 420 V
3 x 500 V 600 V 520 V