gefran TPD32-EV-...-4B - Additional Speed Functions (Add Speed Funct); Adptive Spd Reg; Auto Capture

—————— Instruction manual ——————
223
6.13 ADDITIONAL SPEED FUNCTIONS (ADD SPEED FUNCT)
6.13.1 Auto capture
ADD SPEED FUNCT
[388] Autocapture
Theautocapturefunctionenablestheconvertertoengageaunningmotor.
Parameter description No.
Value
Standard
Conguration
min max
Factory
American
Factory
Standard
Auto capture
ON(1)
OFF(0)
388 OFF(0) OFF(0)
*
*Thisfunctioncanbeassignedtooneoftheprogrammabledigitalinputs.
Auto capture ON Whentheconverterisswitchedon,thespeedofthemotoris
measuredandtherampoutputissetaccordingly.Thedrive
thenrunstothesetreferencevalue.
 OFF Whentheconverterisswitchedon,therampstartsfromzero.
Mainuses: Connectiontoamotorthatisalreadyrunningduetoitsload(e.g.inthecaseof
pumps,theowingmedium).
Reconnectionafterafaultalarm.
Ifthespeedreferencevalueisdenedviatheramp,withAuto capture=ON,startingatareferencevaluecor-
respondingtothemotorspeed.
note!  Ifthefunctionisswitchedoff,ensurethatthemotorisnotturningwhentheconverterisswitched
on.Ifthisisnotthecase,thismaycauseaharshmotordecelerationincurrentlimit.
6.13.2 Adptive spd reg
ADD SPEED FUNCT
Adaptive spd reg
[181] Enablespdadap
[182] Selectadaptype
[183] Adapreference[FF]
[1464] Adapselector
[184] Adapspeed1[%]
[185] Adapspeed2[%]
[186] Adapjoint1[%]
[187] Adapjoint2[%]
[188] AdapPgain1[%]
[189] AdapIgain1[%]
[190] AdapPgain2[%]
[191] AdapIgain2[%]
[192] AdapPgain3[%]
[193] AdapIgain3[%]
[1462] AdapPgain4[%]
[1463] AdapIgain4[%]
Theadaptivespeedregulatorfunctionenablesdifferentgainsofthespeedregulatordependingonthespeedoranother
variable(AdaptiveReference).Thisallowsoptimumadaptationofthespeedregulatortotheapplicaionathand.