EasyManua.ls Logo

gefran TPD32-EV-...-4B - Options; Option 1; Option 2

gefran TPD32-EV-...-4B
504 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
—————— Instruction manual ——————
281
2. Relay2canbedrivenbymeansofPADA/Bbit14.
6.16 OPTIONS
6.16.1 Option 1
OPTIONS
Option 1
Menu
ThroughthismenutheassignementofDriveparameterstothevirtualdigitalI/O(MONITOR\Virtualdigital
Inp-Outmenu)andtotheprocessdatachannels(PDC)oftheeldbuscanbecarriedout.
Ifthebuscardisnotpresentyouwillbeprompted(insidethemenu)bythemessageOPT1 not present.
Iftheusedbuscardisnotup-to-dateforthismanagement,youwillbeprompted(insidethemenu)bythemes-
sageOPT1 old version.
Forfurtheranddetailedinformation,refertothebusinterfaceinstructionbook.
note! StartingwithFWversion10.08(10.25/10.26forTPD32-EV-FC),internalcommunication
betweendriveandinstalledeldbusboard(Probus,CANopen,DeviceNet)issetat2ms.
Thescantimefordatasentbyanexternalmasteris5to6ms.
ForcommunicationwithProbusboard,theupdatedSBI-PDP32boardwithrmware2.400
isrequired.
6.16.2 Option 2
OPTIONS
Option 2
Menu
[425] EnableOPT2
Parameter description No.
Value
Standard
Conguration
min max
Factory
American
Factory
Standard
Menu
Enable OPT2
Enabled(1)
Disabled(0)
425 0 1 Disable Disable
ThismenuallowstheuseraccesstotheparametersetoftheAPC300optioncard.
Menu ThemenuisactiveonlyiftheOPT2cardispresent(e.g.aAPC300card).Iftheusertries
toenterintheOption2menuandthecardisnotmountedonthedevicethemessage
“Notpresent”isdisplayed.
Forfurtheranddetailedinformationseetheinstructionbookoftheoptionalboard.
Enable OPT2 Enabled Whentheconverterisswitchedon,thepresenceoftheAPC300
cardischecked.Ifthecardispresent,the“Menu”parameters
arestartedandtheAPC300parameterscanbereached.
Disabled Whentheconverterisswitchedon,thepresenceoftheAPC300
cardisnotchecked.Therefore,theoptionparametersarenot
takenintoconsiderationeventhoughthecardispresent.
Defaultconguration=Disabled.

Table of Contents

Related product manuals