gefran TPD32-EV-...-4B - Page 282

—————— TPD32-EV ——————
282
 Tochangetheconguration:
 1-setthenewvalueofEnable OPT2parameter
 2-storeviatheSave parameters(BASICMENU)
 3-switch-offandswitch-onthedrive
IfEnabledandtheAPC300cardisnotpresent,willbegeneratedtheerror:
OPT2 failure code 100-98 or OPT2 failure code 100-96.
note WhenusingtheAPC300card(Option2),allparameterslistedinthe“Opt2-A/PDC”column
ofParameterList(section10.1and10.2)canbeaccessedthroughtheautomaticasynchronous
communication.ParameterslistedintheHighPriorityParameterList(section10.2)canbe
accessedbymeansoftheautomaticsynchronouscommunication.(SeeAPC300manualfor
moredetails.)
 IfthesoftwarehasdetectedthepresenceoftheAPC300theparametersetoftheoptionalcard
isaccessible.InthiscaseseetheAPC300usermanualfordetailedinformation.