gefran TPD32-EV-...-4B - Commissioning; Setting Jumpers and Switch

—————— Instruction manual ——————
117
5.3 COMMISSIONING
Warning!  Thesafetyinstructions,dangerwarningsandtechnicaldatainSection1and2ofthismanual
mustbeobserved!
Definitions: Positive speedisclockwiserotationseenfromthemotorshaftendside.
Negative Speediscounter-clockwiserotationseenfromthemotorshaftendside.
Positive torqueistorqueinclockwisedirectionseenfromthemotorshaftendside.
Negative torqueistorqueincounter-clockwisedirectionseenfromthemotorshaftendside.
5.3.1 Setting jumpers and switch
ThehardwarecongurationsetviathejumpersandswitchesontheR-TPD32regulatorcardmustbeadapted
totheapplicationathandandcheckedbefore switching on the device.
- Analoginputs1/2/3
 Voltageinput0...10V    JumperS9/S10/S11=OFF
 Currentvoltage0...20mA/4...20mA  JumperS9/S10/S11=ON
 Mixedpossibleconguration
- Adaptationforthespeedfeedbacktype
 SinusoidalEncoder    JumperS5/S6inpositionA
 DigitalEncoder     JumperS5/S6anyposition
 Analogtachometergenerator   JumperS5/S6inpositionB
 Armaturereaction     JumperS5/S6anyposition
- Adaptationforthedigitalencodervoltage
 Voltage=5V     JumperS21/S22/S23=ON
 Voltage=15...30V    JumperS21/S22/S23=OFF
- ControlofadigitalencoderconnectedtotheconnectorXE2
 ChannelCcontrolled    JumperS20=ON
 ChannelCnotcontrolled    JumperS20=OFF
- Adaptationofthemaxvoltageusingatachometergenerator:
 22.7/45.4/90.7/181.6/302.9V,  
dependingonthedipswitchS4setting(seechapter4.4.3)
- SerialinterfaceRS485
 Ontherstandlastdropofaline:   JumperS12/S13=ON
 Ontheotherconverters    JumperS12/S13=OFF
- RS485serialinterface
 -dividedfromtheregulation   JumperS18/S19inpositionOFF
 (Anexternal5Vpowersupplyisneeded        
onthePINs5and9)seesection4.5.2
 -withacommonpotential0Voftheregulation JumperS18/S19inpositionON
 (Internalpowersupply)
Forfurtherinformationseesection4.4,“Regulationsection”.