GEM Hemochron 100 - Adjust the Beep Volume; View System Information

3 - Instrument Settings
28 / 112
000HZ6006EN.US • 02 • GEM Hemochron 100 Operator Manual
3.2.4 Adjust the Beep Volume
The instrument beeps under the following conditions:
● When the instrument is powered on.
● When an item on the screen is selected.
● At critical points during a test, such as when a test ends or an error message is displayed.
To Adjust the Beep Volume or Turn Off the Beep:
1 Select (Settings) > User Settings.
2 Drag the Volume slider horizontally to the desired level ( Figure 18 ).
NOTE: To turn the beep o󰀨, move the slider to 0 (zero). When the beep is o󰀨, it will only beep at critical
points during testing.
Figure 18 : Adjusting Brightness and Beep Volume
3.2.5 View System Information
To view read-only information about the instrument hardware and software:
● Select (Settings) > User Settings > System Information.
3.2.6 Adjust the Font Size
1 Select (Settings) > User Settings > Font Size.
2 In the dialog box ( Figure 19 ), select the preferred size (Normal or Large).
Figure 19 : Adjusting Font Size