GEM Hemochron 100 User Manual

3 - Instrument Settings
36 / 112
000HZ6006EN.US • 02 • GEM Hemochron 100 Operator Manual
37 / 112
000HZ6006EN.US • 02 • GEM Hemochron 100 Operator Manual
NOTE: Network access must be restricted and isolated to the minimum required communication ports and
protocols. This is a shared responsibility; the device should limit the exposed ports and the customer
provided network shall be isolated/segmented from the business network. The segmentation should be
provided by VLAN or by rewall, whichever is preferred. All unnecessary ports, protocols, and services
should be blocked (e.g., ICMP).
Disconnect from a Wireless Network:
To disconnect from a wireless network:
1 Select (Settings) > Supervisor Settings > Instrument Settings > Wi-Fi.
2 Select the network name and a dialog box for the wireless network is displayed.
3 Select Forget to disconnect the instrument from the wireless network.
Check the Quality of a Wireless Network Signal:
To check the quality of a wireless network signal:
1 Select (Settings) > Supervisor Settings > Instrument Settings > Wi-Fi.
2 Select the network name and a dialog box containing the details of the wireless network is displayed.
NOTE: The indicator is a relative indication. See “Wi‑Fi Signal Strength” (page 45).
3.3.8 Language
1 Select (Settings) > Supervisor Settings > Instrument Settings > Language.
2 In the dialog box, select the preferred instrument language:
● English
● Spanish (Español)
● French (Français)
● Italian (Italiano)
● German (Deutsch)
● Portuguese (Português)
3.3.9 View Instrument Information
To view read-only information about the instrument hardware and software:
● Select (Settings) > Supervisor Settings > Instrument Settings > Instrument Information.
3.3.10 Congure a POCT1‑A Network
Supervisors can congure a POCT1‑A network for use with middleware. A POCT1‑A network allows an
instrument to communicate with other POCT1-A compliant devices.
1 Contact the institution’s network administrator for the IP Address and Port that the instrument will use
when it is connected to the POCT1-A network.
2 Select (Settings) > Supervisor Settings > POCT1-A Network Settings.
3 In the dialog box ( Figure 31 ), enter the IP Address and the Port.
Figure 31 : Conguring POCT1‑A Network Settings

GEM Hemochron 100 Specifications

General

Brand	GEM
Model	Hemochron 100
Category	Measuring Instruments
Language	English