Need help?Do you have a question about the GRAPHTEC WR300 and is the answer not in the manual?
General| Channels | 2 channels |
|---|---|
| Display | LCD |
| Power | 100-240V AC, 50/60Hz |
| Interfaces | USB |
| Paper Speed | 1, 2, 5, 10, 20, 50, 100mm/s |
| Power Supply | 100 to 240 VAC, 50/60 Hz |
General notes and precautions before operating the WR300 Series.
Explains safety precaution categories and symbols used in the manual.
Explains the meaning of safety symbols used in the manual.
Covers secure power connection, grounding, voltage checks, and avoiding electrical shock.
Addresses abnormal operation, disassembly, and suitable environments.
Warns against water exposure and foreign matter on connectors.
Advises against using damaged cords and general safety.
Covers safe storage, avoiding fluids, vibration/noise, and proper cable handling.
Warns about fluid entry and exceeding voltage limits to prevent hazards.
Advises against lubricating mechanisms and using volatile solvents for cleaning.
General description of the WR300/310 Thermal Arraycorder's capabilities.
Details the key features of the WR300/310, including input, display, and recording.
Specifies the recommended operating conditions and locations for the WR300/310.
Identifies and explains the various parts and connectors of the WR300/310 unit.
Explains the names and functions of the buttons and keys on the WR300/310 control panel.
Step-by-step instructions for loading roll and Z-fold chart paper into the WR300.
Instructions for connecting AC and DC power and powering on the WR300/310.
Explains how to connect the WR300 to a PC via LAN or USB cable.
Configuration of input signal amplifiers, including coupling, range, and filters.
Settings for data capture destination, sampling interval, and memory management.
Configuration of trigger conditions for starting and stopping measurements.
Settings related to recording data, including chart speed and display modes.
Options for setting and manipulating cursors for data analysis.
Tools for searching through captured data based on level, time, or other criteria.
Procedures and restrictions for using FFT Mode, including usage methods and limitations.
Settings specific to recording data in FFT Mode, such as frequency, counts, and window functions.
Options for replaying data captured in FFT Mode.
Step-by-step guide for installing the software and performing measurements.
Detailed steps for installing the USB driver and the OPS023 application.
Procedures for setting measurement parameters like amplifier and trigger settings within the software.
Describes starting, stopping, monitoring, saving, scrolling, and cursor functions in the software.
Procedures for transferring data from the WR300 to a PC.
A chart detailing the configuration options available for WR300 and WR310 models.
Outlines the fundamental specifications of the WR300/310 main unit and data capture functions.
Details the specifications for various plug-in amplifier types, such as V, M, DCB, and FV.
A catalog of available options, accessories, and supplies for the WR300/310.
To Next Page