Application Software
5-13
Default Color Settings
The Default Color Settings window sets the default waveform display colors when the software is first
started. The details set are used when the network/USB connection is reset and then reconnected. These
settings are retained within the system memory. Set to the desired colors.
Click "Default Color" in "Settings" on the menu bar to display the following window. Set the required details
and click "OK".
CHECKPOINT
To alter the colors temporarily, use "Format Settings" described in Section 5.7.
CH * – * .......................... Displays the channel group to be set.
Color .............................. Sets the waveform display color for each channel. Click to display the setting
window.
Background/Grid Colors
............................. Sets the background and grid colors for the measurements window.
• Background ............ Sets the background color for the measurements window. Click to display the
setting window.
• Grid ......................... Sets the grid color for the measurements window. Click to display the setting
window.
Logic .............................. Sets the logic waveform display color.
• Group A to P ........... Sets the waveform display color for each logic channel. Click to display the
setting window. Group A corresponds to logic channels 1 to 4 for the first unit.
1st unit 2nd unit ---
8-channel model A, B C, D ---
16-channel model A, B, C, D E, F, G, H ---
To Next Page
Loading...