Recorder Mode
3-33
3.16 Replay Settings
This section describes the Replay Settings window, an example of which is shown below.
CAUTION
When replaying data from a PCMCIA card, do not replace the card with another one even after the data replay
operation has been completed. The replacement procedure may damage the card. If you need to replace the card,
press the MODE key to return the WR300/310 to the measurement status.
(3) Cursor time axis data
(2) Cursor channel data
(1) Cursors
(1) Press the CURSOR key to display the A (B) cursor, and A,B cursors.
(2) When the cursors are displayed, the data for those cursors is displayed.
(3) If only one cursor is displayed, the time data for that cursor is displayed. If two cursors are displayed,
their time data and the time data between the cursors is displayed.
To Next Page
Loading...