2-16
Checks and Preparation
(4) Assemble the guide shaft by attaching a bobbin to each end of the long-length pipe provided as shown
below. Pass the paper over the guide shaft. Pull the leading edge of the paper out of the printer cover's
paper outlet, and then close the printer cover firmly.
Bobbin
Long-length pipe
High Temperature
Right after recording, the thermal head may be very hot and cause burns or other injuries if accidentally touched.
Before replacing the chart paper, allow the thermal head to adequately cool down.
CAUTION
When loading the chart paper, take care not to damage the thermal head. Recording will not be performed
correctly if the thermal head is damaged.
(5) In the Customize Settings window, select "Use" for 100m Z-fold Chart Unit" (see Section 3.13).
Cutting the Chart Paper
To cut off a length of chart paper, hold the leading edge so that it faces the control panel, and then pull it in
the direction shown by the arrow so that it passes along the edge of the cutter.
To Next Page
Loading...