GRAPHTEC WR300 - Recorder Mode Menu Tree Structure

3-2
Recorder Mode
3.1 Recorder Mode Menu Tree Structure
Menu Item Details Section
1. Amp Settings AMP The installed amps are displayed 3.2
Input
Range
Filter
Misc. Zero point adjustment, Auto balance,
Other
Scaling The Scaling status (including the
units is displayed)
Lower-SPAN-Upper Unit
Logic
Threshold
2. Memory Settings Common Settings Capture Destination 3.3
Sampling Interval
Time Scale
Program Block
Data Memory Settings Block Size
Capture Time The time is displayed
Memory Chain
Calculation Processing
Capture Block
Auto Save
Common Settings Sampling Interval
Time Scale
Data Disk Settings File Name
3. Trigger Settings Common Settings Function 3.4
Time Gate
Action
Start Condition Source
Pre-trigger
Stop Condition Source
4. Record Settings Record Settings Function 3.5
Chart Speed
V1 Setting
V2 Setting
Waveform Display Mode
Channel ID
Function
Output Mode
Waveform Display Mode
Channel ID
Print Record Settings Scale Print
List Print
5. Data Replay Replay Source Settings Replay Source 3.6
Settings Replay Block
Data Save Conditions Sampling Interval The data capture sampling interval is
displayed
Time Scale The time scale axis unit is displayed
No. of Data The number of data points is displayed
Replay View Settings Replay CH
Output Ratio
Data Save
Replay Source Settings Replay Source
File Name
Data Save Conditions Sampling Interval The data capture sampling interval is
displayed
Time Scale The time scale axis unit is displayed
No. of Data The number of data points is displayed
Replay View Settings Replay CH
Output Ratio
Disk
Memory
Memory
Direct
Disk
Memory