GRAPHTEC WR300 - Loading Z-Fold Paper in the Long-Length Z-Fold Unit (Option)

Checks and Preparation
2-15
Loading Z-Fold Paper in the Long-Length Z-Fold Unit (Option)
(1) Mount the main unit onto the long-length Z-fold unit. As shown below, fit the main unit's rubber feet into
the round openings on the top surface of the long-length Z-fold unit.
B-522: 200-mm width long-length Z-fold unit
for WR300-8, WR300-16, WR310-8, WR310-16
(2) Load the chart paper in the long-length Z-fold unit tray and then insert the tray into the long-length Z-fold
unit. At this time, do not insert the tray fully Leave part of the tray outside of the unit.
Long-length Z-fold unit tray
Pass through here
200-mm width Z-Fold Paper: PZ231A
(3) Lower the printer open lever, open the printer cover, insert the leading edge of the Z-fold paper in into
the space below the main unit's printer cover, and then pull it out as shown.