3-24
Recorder Mode
3.9 Annotation Settings
(4) (5)
(1)(2)(3)
(1) Print Interval ............. Sets the print interval for annotation printing between 10 and 100 cm.
(2) Length....................... Sets the number of characters for annotation printing between 10 and 32.
(3) Flying Annotation ...... Sets flying annotation on or off. When set to "On", annotation print control is
possible from a PC.
(4) Title Annotation ......... Prints a title at the top of the chart paper.
Off : Disables the Title Annotation function.
System : Prints the date, starting time, and chart speed.
User : Prints a user-defined character string as the title. When this
setting is selected, a submenu appears for inputting the title
character string, so input a title that is no longer than the number
of characters specified by the Length setting.
System & User : Prints the information described under the System setting and
then prints a user-defined character string as the title.
(5) CH Annotation .......... Prints a commentary character string for each channel.
Off : Disables the CH Annotation function.
Amp : Prints the currently selected Range, Input, Filter and Span settings
for each channel.
User : Prints a user-defined character string for each channel. When this
setting is selected, a submenu appears for inputting a channel-
specific comment, so input a character string that is no longer than
the Length setting.
Amp & User : Prints the information described under the Amp setting and then
prints a user-defined comment.
Value : Prints the measured values.
CHECKPOINT
• When the CH Annotation setting is Amp & User, the print interval and the number of
characters printed are respectively determined by the Print Interval and Length settings.
• When the CH Annotation setting is Value, the measured value at the position indicated
by the ∇ symbol where the title is usually printed is printed. The print interval of the ∇
symbols is determined by ∇ the Print Interval setting.
To Next Page
Loading...