5-2
Application Software
5.1 Procedures from Installation to Measurement
This section describes the procedures and system requirements for installing the application software and
using it for measurements.
Procedures from Installation to Measurement
Function Differences Between the Monitor and the OPS023
Step Setting For details
Section
1 Install USB driver 5.4
2 Install OPS023
3 Set IP address and ID No. 5.5
4 Set data saving destination 5.6
5 Set default color settings
6 Set OPS023 communication Set IP address/ID No. of WR300 to be connected using
Check connection destination using
Connect using
7 Synchronize date/time
8 Set measurement conditions Make Amplifier settings 5.7
Make Trigger Settings
Make Memory settings
Make Span settings
Make EU settings
Make Format settings
Save/Load Setup Parameters
9 Start measurement/monitoring [Start Measurement] Start measurement using 5-8
[Start Monitoring] Start monitoring using
10 Stop measurement/monitoring Stop measurement/monitoring using
11 Save measurement data
12 Scroll measurement data
13 Search
14 2-screen
15 Convert data format and save
Item WR300 OPS023
FFT mode Yes No
Fixed display mode Yes No
2-screen display No Yes
Report file No Yes
Data conversion TXT only CSV, TXT, GBD, DADiSP
To Next Page
Loading...