Application Software
5-21
Start/Stop/Monitor/Replay
Start
Click "Measure" → "Start" on the menu bar or click to start measurement. The Min/Max waveform data is
displayed on the screen while data is being captured into memory of the WR300 or another storage medium.
Stop
Click "Measure" → "Stop" on the menu bar or click to stop measurement. When measurement is started
by clicking , the Min/Max data on the screen will be saved automatically.
Monitor
Click "Measure" → "Monitor" on the menu bar or click to start measurement. The waveform is only
displayed on the monitor screen and is not captured.
Replay
Click "Measure" → "Replay" on the menu bar or click to display data captured on the WR300. When the
display format is set to 1/1 magnification, about 50 data/div will be read out and displayed. When full-screen
width is selected, the "Reading measurement data..." message will appear on the screen during the reading
and display of all data.
Loading and Saving Setup Parameters
This section describes how to load and save measurement settings. Click "File" on the menu bar to display
the Settings window.
Load Settings....
To load previously saved settings, click "Load Settings" to display the files saved in the destination folder in
the "Open" window. Select the file you want to load (*.gcn) and then click the "Open" button to display the file
condition settings.
To Next Page
Loading...