Recorder Mode
3-35
3.18 Search Settings
(1)
(6)
(4) (5)(2)(3)
[Search Settings]: These settings enable a search of the displayed Replay data to be performed. The
Search settings are as follows.
(1) Next Level Match ...... The next point in the data after the current data that satisfies the search condition
is displayed on the screen.
(2) Prev. Level Match ..... The previous point in the data after the current data that satisfies the search
condition is displayed on the screen.
(3) Combination ............. Selects the method for satisfying the Level condition.
OR : Searches for the position where a single channel among the target channels
satisfies the search condition (which has not yet been met any other
channel).
AND : Searches for the position where all of the target channels satisfy the search
condition.
(4) Mode......................... Selects the Level condition.
Off : Set this condition for any channel that is to be excluded from the Data
Search operation.
H : The Level condition is satisfied when an input waveform exceeds the
specified Level value.
L : The Level condition is satisfied when an input waveform falls below the
specified Level value.
Win In : Sets the Lower-limit and Upper-limit levels for each channel. The Level
condition is met when a captured waveform goes inside both the
specified Lower-limit and Upper-limit levels.
Win Out : Sets the Lower-limit and Upper-limit levels for each channel. The Level
condition is met when a captured waveform goes outside both the
specified Lower-limit and Upper-limit levels.
(5) Lower - Level - Upper
............................. Sets the search levels for captured data. Set the level in a range of -100% to
+100% in 1% steps. If the Mode setting is Win In or Win Out, be sure to set the
difference between the Lower and Upper Levels to 5% or more. (The Lower limit of
the specifiable range is -100% and its Upper limit is +100%).
Example: For a 5 V range: -5V = -100%, +5V = +100%
To Next Page
Loading...