5-26
Application Software
Use Logic ................ Adds logic signals to the search conditions
Mode ....................... Sets the search mode for each channel
• H ...................... The search condition is satisfied when the position exceeds the level set in Level 1.
• L.......................
The search condition is satisfied when the position falls below the level set in Level 1.
• Window In........ The search condition is satisfied when the position goes inside both the levels set
in Level 1 and Level 2.
• Window Out ..... The search condition is when the position goes outside both the specified levels set
in Level 1 and Level 2.
Logic ....................... Sets the search level for each logic channel
• H ...................... Searches for the High position.
• X ...................... Set this condition for any channel to be excluded.
• L....................... Searches for the Low position.
Search Counter....... This function sets the number of points to be considered invalid until the search
conditions are satisfied.
• Counts ............. Searches for the position where the trigger condition has been satisfied the
specified number of times. The setting range is 1 to 255.
• Filter................. Searches for the position where the search conditions are satisfied for the set time
or longer. The actual time is the product of the sampling interval and filter settings.
TIP
When the search condition is met, the status of the targeted point changes from a "no match" point to a
"matched" point. Once the starting point satisfies the search condition, that point is ignored until it no longer
satisfies it.
Jump ....................... Date/Time, Position
Specify the date and time, and then click the Time Jump button to jump to the
specified date and time. Specify the measured point, and then click the Position
Jump button to jump to that position.
2-Screen Display
This allows you to view measurement data on a dual screen.
CHECKPOINT
The following data files cannot be used for this operation:
• Data that was captured with an automatically-generated file name (files with a .gmd extension).
• Data that was captured using multiple WR300 units connected together (files with a .gmd extension).
To Next Page
Loading...