Application Software
5-33
5.12 Report Function
This section describes the functions for creating a report using captured data. The waveform displayed on
the screen is saved as a BMP or WMF file format (the amp settings for each channel are included).
(1) Select "Make Report" in "File" on the menu bar or click to display the Make Report window.
(2) Output area settings
These are used to create a report file to save information together with the waveform.
Comment : Saves the comment at the same time
File name : Saves the file name at the same time
Y scale : Saves the Y axis scale at the same time
Time scale : Saves the time scale at the same time
Waveform data only : Saves the waveform data only. To save the trigger times and the cursor point data
values at the same time, decheck this box.
(3) Output file name
Specifies the name for the report file
CHECKPOINT
Data displayed on a dual screen cannot be used for a report. Only single-screen data can be used. Compress the
waveform using the display ratio, and then use the data. If the saved data is not displayed correctly, change your
monitor's Colors setting to 32 colors and then save the data.
Report Display
To Next Page
Loading...