Checks and Preparation
2-3
2.3 WR300/310 Part Names and Functions
This section describes the names and functions of the WR300/310's parts.
(5) Logic amp
(4) Amplifier mounting section
(3) PCMCIA slot
(7) LAN connector
terminal
(8) USB connector terminal
(9) REMOTE
connector terminal
(11) Power switch
(10) AC power connector
(12) GND
(13) IRIG connector (WR310 only)
(14) Printer open lever
(2) Chart paper unit
(1) Monitor
(6) Control panel keys
(1) Monitor.......................... Displays the setting menus and measurement data.
(2) Chart paper unit ............ Holds the roll paper and the Z-fold paper for internal use. If you want to use
long-length (100-m) Z-fold paper, the external long-length Z-fold paper unit is
required.
(3) PCMCIA slot .................. Used for inserting the PCMCIA card.
(4) Amplifier mounting section
.................................. Used for mounting the preamplifiers.
(5) Logic amp ...................... This is the logic amplifier.
(6) Control panel keys ......... Used for the main operations, including settings, and starting and stopping
measurement.
(7) LAN connector terminal
.................................. Terminal for LAN connection.
(8) USB connector terminal
.................................. Terminal for USB connection.
(9) REMOTE connector terminal
.................................. Terminal for the Remote interface connector.
(10) AC power connector .... Terminal for connecting the AC power cable.
(11) Power switch................ Switch for turning on the power.
(12) GND............................. Used when a ground connection is required.
(13) IRIG connector (WR310 only)
.................................. Signal input/output terminal for IRIG time codes.
(14) Printer open leve ......... Used to open the printer cover when loading chart paper.
CHECKPOINT
To provide protection for the LCD screen, attach the LCD protector provided as a standard accessory.
To Next Page
Loading...