Application Software
5-31
CHECKPOINT
When a range is selected with two cursors displayed, the range is automatically entered.
No Skip .......................... The displayed data or cursor specification is converted directly.
Skip ................................ This setting affects the number of sample points and sampling interval recorded in
the output file header.
• Skip Rate ................ Skips the number of samples in accordance with the capture sampling time when
converting.
• Offset ...................... This function offsets the data to be converted when using skip conversion. The
offset always affects the start of the device data saved rather than the range
specification conversion start point.
Batch Conversion
By selecting "Batch Conversion" in "File" on the menu bar, converted data can be selected as multiple data
files and changed all as one batch into the format you specified for "Format".
CHECKPOINT
Waveform display, channel specification, range specification, etc., cannot be performed. Only data with a " * .DAT",
" * .GDT", or " * .GBD" extension can be converted.
Add................................. Selects the filenames for converting into different formats. The selected files are
added to the Input Files list. To select multiple files, click on each file while holding
down the Ctrl key, or while holding down the Shift key.
Remove.......................... Removes a file from the Input Files list (the file itself is not actually deleted, only
removed from the list). Select the file you want to remove from the list by clicking
on it, and then click on the [Remove] button to remove it.
Remove All ..................... Removes all the files from the Input Files list (the files themselves are not actually
deleted, only removed from the list).
Start Conversion ............ Converts all the files registered in the Input Files list to the specified format, and
then saves the data. Specify your preferred directory so that all the converted files
will be saved to that directory.
Stop Conversion ............ Stops data conversion of only the file that is currently being converted.
Quit Conversion ............. Stops data conversion of the file that is currently being converted, as well as the
files that conversion was specified for, but have not yet been converted.
Common Settings .......... Selects the Format and OverWrite details.
• Format .................... The output file format can be selected from among the following.
To Next Page
Loading...